Share

Focused-ion-beam-assisted magnet fabrication and manipulation for magnetic field detection applications.

Humberto Campanella, R P del Real, Marina Díaz-Michelena, Marta Duch, Héctor Guerrero, Jaume Esteve, José A Plaza

PAPERpubmedACS applied materials & interfaces2009engineeringEffect: unclearEvidence: Insufficient

Abstract

A focused-ion-beam-assisted technique intended for ultrasmall, hard-magnet fabrication has been developed. By means of ion-beam-induced milling and deposition, reduced-size NdFeB magnets were extracted from a macroscopic quarry and bonded to the surface of a thin-film bulk acoustic resonator (FBAR). Electrical characterization of the FBAR before and after bonding of the magnet was carried out, thus observing both a downshifting of the resonance frequency and a reduction of the quality factor of the resonator. The magnetic behavior of the nanomagnet has been confirmed by means of magnetometry measurements based on atomic force microscopy.

AI evidence extraction

At a glance
Study type
engineering
Effect direction
unclear
Population
—
Sample size
—
Exposure
Evidence strength
Insufficient
Confidence: 74% · Peer-reviewed: yes

Main findings

A focused-ion-beam-assisted milling/deposition technique was used to fabricate reduced-size NdFeB magnets and bond them to a thin-film bulk acoustic resonator (FBAR). Electrical characterization showed a downshift in resonance frequency and a reduction in the resonator quality factor after magnet bonding; magnetic behavior was confirmed using AFM-based magnetometry.

Outcomes measured

  • FBAR resonance frequency shift after bonding NdFeB nanomagnet
  • FBAR quality factor change after bonding NdFeB nanomagnet
  • Magnetic behavior confirmation via AFM-based magnetometry
View raw extracted JSON
{
  "study_type": "engineering",
  "exposure": {
    "band": null,
    "source": null,
    "frequency_mhz": null,
    "sar_wkg": null,
    "duration": null
  },
  "population": null,
  "sample_size": null,
  "outcomes": [
    "FBAR resonance frequency shift after bonding NdFeB nanomagnet",
    "FBAR quality factor change after bonding NdFeB nanomagnet",
    "Magnetic behavior confirmation via AFM-based magnetometry"
  ],
  "main_findings": "A focused-ion-beam-assisted milling/deposition technique was used to fabricate reduced-size NdFeB magnets and bond them to a thin-film bulk acoustic resonator (FBAR). Electrical characterization showed a downshift in resonance frequency and a reduction in the resonator quality factor after magnet bonding; magnetic behavior was confirmed using AFM-based magnetometry.",
  "effect_direction": "unclear",
  "limitations": [],
  "evidence_strength": "insufficient",
  "confidence": 0.74,
  "peer_reviewed_likely": "yes",
  "keywords": [
    "focused ion beam",
    "NdFeB",
    "nanomagnet",
    "hard magnet fabrication",
    "thin-film bulk acoustic resonator",
    "FBAR",
    "resonance frequency",
    "quality factor",
    "AFM magnetometry"
  ],
  "suggested_hubs": []
}

AI can be wrong. Always verify against the paper.

AI-extracted fields are generated from the abstract/metadata and may be incomplete or incorrect. This content is for informational purposes only and is not medical advice.

Comments

Log in to comment.

No comments yet.

NNEMF synthesis

Synthesis pending.

Original record: rfsafe.org paper 3337

Focused-ion-beam-assisted magnet fabrication and manipulation for magnetic field detection applications. · Non-native EMF