Downlink power distributions for 2G and 3G mobile communication networks.
Abstract
Knowledge of realistic power levels is key when conducting accurate EMF exposure assessments. In this study, downlink output power distributions for radio base stations in 2G and 3G mobile communication networks have been assessed. The distributions were obtained from network measurement data collected from the Operations Support System, which normally is used for network monitoring and management. Significant amounts of data were gathered simultaneously for large sets of radio base stations covering wide geographical areas and different environments. The method was validated with in situ measurements. For the 3G network, the 90th percentile of the averaged output power during high traffic hours was found to be 43 % of the maximum available power. The corresponding number for 2G, with two or more transceivers installed, was 65 % or below.
AI evidence extraction
Main findings
Downlink output power distributions for 2G and 3G base stations were derived from Operations Support System network measurement data and validated with in situ measurements. For 3G, the 90th percentile of averaged output power during high traffic hours was 43% of maximum available power; for 2G with two or more transceivers installed, the corresponding value was 65% or below.
Outcomes measured
- Downlink output power distributions for 2G and 3G radio base stations
- 90th percentile of averaged output power during high traffic hours (3G and 2G)
- Validation of method using in situ measurements
Suggested hubs
- occupational-exposure (0.7)Base-station power data may inform exposure assessment, but no occupational setting is explicitly described.
View raw extracted JSON
{
"study_type": "exposure_assessment",
"exposure": {
"band": "RF",
"source": "base station",
"frequency_mhz": null,
"sar_wkg": null,
"duration": null
},
"population": null,
"sample_size": null,
"outcomes": [
"Downlink output power distributions for 2G and 3G radio base stations",
"90th percentile of averaged output power during high traffic hours (3G and 2G)",
"Validation of method using in situ measurements"
],
"main_findings": "Downlink output power distributions for 2G and 3G base stations were derived from Operations Support System network measurement data and validated with in situ measurements. For 3G, the 90th percentile of averaged output power during high traffic hours was 43% of maximum available power; for 2G with two or more transceivers installed, the corresponding value was 65% or below.",
"effect_direction": "unclear",
"limitations": [],
"evidence_strength": "insufficient",
"confidence": 0.74,
"peer_reviewed_likely": "yes",
"keywords": [
"EMF exposure assessment",
"downlink",
"output power distribution",
"2G",
"3G",
"radio base station",
"Operations Support System",
"network measurement data",
"in situ measurements",
"traffic hours"
],
"suggested_hubs": [
{
"slug": "occupational-exposure",
"weight": 0.1,
"reason": "Base-station power data may inform exposure assessment, but no occupational setting is explicitly described."
}
]
}AI can be wrong. Always verify against the paper.
Comments
Log in to comment.
No comments yet.
NNEMF synthesis
Synthesis pending.