Share

Responsive behavior of regenerated cellulose in hydrolysis under microwave radiation.

Jinping Ni, Haining Na, Zhen She, Jinggang Wang, Wenwen Xue, Jin Zhu

PAPERpubmedBioresource technology2014OtherEffect: unclearEvidence: Insufficient

Abstract

This work studied the responsive behavior of regenerated cellulose (RC) in hydrolysis under microwave radiation. Four types of RC with different crystallinity (Cr) and degree of polymerization (DP) are produced to evaluate the reactivity of RC by step-by-step hydrolysis. Results show Cr is the key factor to affect the reactivity of RCs. With hydrolysis of amorphous region and the formation of recrystallization, the Cr of RC reaches a high value and thus weakens the reactivity. As a result, the increment of cellulose conversion and sugar yield gradually reduces. Decrease of the DP of RC is helpful to increase the speed at the onset of hydrolysis and produce high sugar yield. But, there is no direct influence with the reactivity of RC to prolong the time of pretreatment. This research provides an accurate understanding to guide the RC preparation for sugar formation with relative high efficiency under mild reaction conditions.

AI evidence extraction

At a glance
Study type
Other
Effect direction
unclear
Population
—
Sample size
—
Exposure
microwave
Evidence strength
Insufficient
Confidence: 66% · Peer-reviewed: yes

Main findings

In step-by-step hydrolysis of regenerated cellulose under microwave radiation, crystallinity (Cr) was reported as a key factor affecting reactivity; increasing Cr during hydrolysis (via amorphous-region hydrolysis and recrystallization) weakened reactivity and reduced incremental gains in conversion and sugar yield. Lower degree of polymerization (DP) increased the initial hydrolysis speed and enabled higher sugar yield, while prolonging pretreatment time was reported to have no direct influence on reactivity.

Outcomes measured

  • cellulose hydrolysis reactivity
  • cellulose conversion
  • sugar yield
  • crystallinity (Cr) changes
  • degree of polymerization (DP) effects
View raw extracted JSON
{
  "study_type": "other",
  "exposure": {
    "band": null,
    "source": "microwave radiation",
    "frequency_mhz": null,
    "sar_wkg": null,
    "duration": null
  },
  "population": null,
  "sample_size": null,
  "outcomes": [
    "cellulose hydrolysis reactivity",
    "cellulose conversion",
    "sugar yield",
    "crystallinity (Cr) changes",
    "degree of polymerization (DP) effects"
  ],
  "main_findings": "In step-by-step hydrolysis of regenerated cellulose under microwave radiation, crystallinity (Cr) was reported as a key factor affecting reactivity; increasing Cr during hydrolysis (via amorphous-region hydrolysis and recrystallization) weakened reactivity and reduced incremental gains in conversion and sugar yield. Lower degree of polymerization (DP) increased the initial hydrolysis speed and enabled higher sugar yield, while prolonging pretreatment time was reported to have no direct influence on reactivity.",
  "effect_direction": "unclear",
  "limitations": [],
  "evidence_strength": "insufficient",
  "confidence": 0.66,
  "peer_reviewed_likely": "yes",
  "keywords": [
    "microwave radiation",
    "regenerated cellulose",
    "hydrolysis",
    "crystallinity",
    "degree of polymerization",
    "cellulose conversion",
    "sugar yield",
    "recrystallization"
  ],
  "suggested_hubs": []
}

AI can be wrong. Always verify against the paper.

AI-extracted fields are generated from the abstract/metadata and may be incomplete or incorrect. This content is for informational purposes only and is not medical advice.

Comments

Log in to comment.

No comments yet.

NNEMF synthesis

Synthesis pending.

Original record: rfsafe.org paper 6559

Responsive behavior of regenerated cellulose in hydrolysis under microwave radiation. · Non-native EMF